JavaScript is Disabled
Your browser's JavaScript functionality is disabled. It has to be enabled to use this function of ConfTool.
Here you can find information on how to enable JavaScript
If you have any problems, please contact the organizers at eosam@europeanoptics.org.

Conference Agenda

Please note small changes to the agenda are still possible.

Read about the Topical Meetings and sessions of the conference

Select a date or location to show sessions only on that day or location.
Select a single session for a detailed view (with abstracts and downloads when you are logged in as a registered attendee).

Please note that all times are shown in the time zone of the conference. The current conference time is: 10th June 2025, 10:50:15am CEST

Session Overview

Session

PLENARY: Digital Holographic Microscopy in overlay metrology for the semiconductor industry by Arie de Boef

Time:

Wednesday, 27/Aug/2025:

10:30am - 11:15am

Device density in semiconductor chips continues to increase through many innovations. For example, high-NA EUV lithography enables the printing of smaller features that allow more devices in a smaller area. In addition, many innovations are taking place in the area of 3D device integration where devices are stacked on each other.
Manufacturing state-of-the-art chips with sufficient yield requires good control of many process steps during manufacturing. Overlay, for example, is a critical parameter in chip manufacturing. Overlay describes the lateral mis-alignment between 2 overlapping layers in a device. Any misalignment (=overlay error) can result in significant yield loss and overlay must therefore be controlled to the 1 nm level. These levels of control need accurate and robust overlay metrology.
Overlay is often measured on dedicated targets using optical microscopy. However, robustly achieving sub-nanometer precision requires near-perfect microscopic imaging conditions which drives the need for high-quality imaging optics with very low aberration levels. Technically this is possible, but it leads to complex and costly optical imaging systems. In order to keep metrology costs to acceptable levels there is a need for a microscopy approach that achieves the sub-nanometer precision levels in a more cost-efficient way.